Printing Instructions

Please use this AJ Flex Shield design to print with the solid cap

For any 3D printer

For XYZ DaVinci printers

Please print one print at a time without stacking as it makes the assembly process easier.

Please use this AJ Flex Shield design to print without the solid cap

For any 3D printer

For XYZ DaVinci printers

Please print one print at a time without stacking as it makes the assembly process easier.

Below are the instructions if using Terrafilum ABS and using XYZ DaVinci Pro printer.

Average print time 1-hour. Filament usage: 7.5 m.

Filament settings:

• This material likes to run hot.
• Recommended temp 240℃-260℃ (245℃ has been successful)
• Bed 80℃ (90℃ if the room is cold)
• Layer cooling fan speed is 20%

Print settings: These setting worked ONLY FOR ABS

• No infill
• 2-layer perimeter
• 3 layers top and bottom
• Speed up to 60mm/s
• 40mm/s for bridge
• No supports
• No raft
• Brim (2mm optional)